● Model: BM200-DI/I
● Input Signal: DC0~20mA / 4~20mA
● Output Signal: DC0~20mA / 4~20mA
● Channel Type: 1 in 1 out, 1 in 2 out, 2 in 2 out
● Power Supply: DC20~35V
● 35mm Din Rail Installation
General
BM200 isolated safety barrier can transmit signals between the safe area and the dangerous area, and limit the energy transfer from the safe area to the dangerous area caused by the fault. The voltage, current, temperature, resistance signals generated by the equipment (transmitter) on the dangerous side are isolated and converted into corresponding linear voltage and current signals outputting to the safe area. The product requires independent power supply, and the input/output/power supply is isolated. It can be used in current source, two-wire, three-wire transmitter equipment.
Features
① It can directly isolate the loop signal in the dangerous area from the signal in the safe area;
② It can allow the instrument to be grounded on site, especially there are many protective function circuits, and it allows live maintenance on site;
③ Compared with other devices, analog signal voltage isolator is still very good in signal processing.
Dimension
Wiring
BM200-DI/I-B11
BM200-DI/I-C12
BM200-DI/I-C22
Structure
Application
Photos on Site
|
Type |
BM200-DI/I-B11、BM200-DI/I-C12、BM200-DI/I-C22 |
|
Channel type |
1 in 1 out, 1 in 2 out, 2 in 2 out |
|
Input type |
Current |
|
Output signal |
0～20mA/4～20mA (Distribution voltage: 14.0V/20mA) |
|
Output Signal |
0～20mA /4～20mA (safety side output); Load resistance: ≤550Ω |
|
Transmission accuracy |
0.2% |
|
Temperature drift |
50ppm |
|
Response time |
5ms to reach 90% of final value |
|
Supply voltage |
20～35V DC |
|
Consumption |
24V power supply, 20mA output: ≤70mA (one in, one out) ≤110mA (one in, two out) ≤160mA (two in and two out) |
|
Working temperature |
-20℃～+60℃ |
|
Storage temperature |
-40℃～+80℃ |
|
Relative humidity |
≤95%RH, no condensation, no corrosive gas place |
|
Altitude |
≤2500m |
|
Protection level |
IP20 |
|
Weight |
About 110g (12.5mm shell) About 150g (22.5mm shell) |
|
Installation |
Din-rail mounted |
|
Dielectric strength |
Intrinsically safe end and non-intrinsically safe end ≥ 2500V AC; power supply and non-intrinsically safe end ≥ 500V AC |
