● Model: ACTDS-DV
● Rated current input: 100-1500V
● Rated output: 5V / 4-20mA
● Power supply: 12V / 15V / 24V
● Accuracy: Class 1.0
ACTDS series DC voltage sensors are the measuring module that converts the measured DC voltage into the proportional DC current or DC voltage signal according to the optical isolation theory. The input side is highly insulated from the output side. They feature the high accuracy, linearity and integration, small size, simple structure, long-term stability and adaptability to various working conditions.They are widely used for system control and detection of electrical equipment in the power, petroleum, mine, chemical, railway, communication, building automation sectors.
★ Measurement of DC voltage
★ Quick response
★ Large overload capacity
★ High accuracy
★ DIN rail mounting
★ 3.5kV insulation between the input side and the output side
Specification
Type
Rated voltage
Rated output
Installation
Power Supply
ACTDS-DV
100-1500V
5V/4-20mA
Rail mounted
12V/15V/24V
AHVS-L100
50-2500V
50mA
Rail mounted
±15V-±24V
AHVS-LV
100-4000V
50mA
Rail mounted
±15V-±24V
Dimension
Spec. and size (unit：mm)
Wiring
1. When the hall sensor is used, in order to obtain better dynamic characteristics and sensitivity, attention must be paid to the coupling between the primary side coil and the secondary side coil. It is recommended to use a single wire and the wire completely fills the hall sensor module wire hole;
2. When the hall sensor is used, the best measurement accuracy can be obtained under the rated input current value. When the measured current is far lower than the rated current To obtain the best accuracy, multiple turns can be used for the primary side, i.e. IPNP = rated ampere turns. In addition, the temperature of the primary side feeder shall not exceed 80 ℃;
3. The auxiliary power supply of Hall current sensor shall not exceed ± 20% of the calibrated value when it works normally;
4.Hall current sensor shall not fall from a high place (≥ 1m) during installation and use;
5. It is unable to adjust the zero point and full degree adjustment potentiometer;
6. Auxiliary power supply needs to be configured by itself;
7. The positive and negative poles of the power supply cannot be reversed.
Related Solution
